Specifications; Standard Equipment; Tool Inspection - RIDGID RE 130-M Manual De Instrucciones

RE 130-M/RE 12-M Manual Hydraulic Crimp Tool
The carrying case can accommodate 15 pairs of dies, the
instruction manual and the crimp head stand in addition to
the tool.
The RIDGID ® RE 130-M/RE 12-M Manual Hydraulic
Crimp Tools are intended to be used with commercially
available round dies, with appropriate ratings, for crimping
electrical connectors onto wire.
See the supplied RIDGID Crimp Die/Electrical Connector
Compatibility Chart or go to www.RIDGID.com/CrimpDies
Stationary Die
Holder
Die
Release
Movable Die
Buttons
Holder
Warning Label
Serial Plate
Crimp Head
Model Number
Figure 1 – RE 130-M/RE 12-M Manual Hydraulic Crimp
Tool

Specifications

RE 12-M
Nominal
Piston Force.....12 ton
(107kN,
24,000 lbf)
Dies..................Round, 12 ton
Max. Cable
Capacity...........750 MCM
Copper
Building Wire,
750 MCM
Aluminum
Building Wire
Piston Travel....1.65"
(42mm)
Operating
Temperature.....-4°F to 104°F
(-20°C to 40°C)
Dimensions.......21.9" x 8.2" x 3.2"
557 x 208 x 82mm 557 x 208 x 82mm
Weight ..............11.68 lb (5.3 kg)
The tool serial number is located on the name plate as
shown in Figure 2. The last 4 digits indicate the month and
year of manufacture (06 = month, 14 = year).
4
Movable
Handle
Release
Handle
Lever
RE 130-M
130kN
(29,225 lbf)
Round, 130 kN
400 mm 2
Copper Cable,
240 mm
2
Aluminum
Cable
1.65"
(42mm)
-4°F to 104°F
(-20°C to 40°C)
21.9" x 8.2" x 3.2"
11.68 lb (5.3 kg)
Figure 2 – Tool Serial Number

Standard Equipment

The RIDGID ® Model RE 130-M or RE 12-M Manual
Hydraulic Crimp Tool comes with the following:
• Operator's Manual
• Die Slot Marking Decals (imperial or metric sizes)
• Crimp Head Stand
NOTICE Selection of appropriate materials and joining
methods is the responsibility of the system designer
and/or installer. Before any installation is attempted, care-
ful evaluation of the specific requirements should be
completed. Consult connector manufacturer for selec-
tion information.

Tool Inspection

WARNING
Daily before use, inspect your crimp tool and correct
any problems to reduce the risk of serious injury
from crushing injuries and other causes, and to
prevent tool damage.
1. Clean any oil, grease or dirt from the tool, including
the handles. This aids inspection and helps prevent
the tool from slipping from your grip.
2. Inspect the crimp tool for the following:
• Proper assembly, maintenance and complete-
ness.
• Any broken, worn, missing, misaligned or binding
parts or other damage.
• Hydraulic leaks. Oil in the carrying case can indi-
cate a hydraulic leak.
• Presence and readability of warning label and
markings (Figure 1) .