Oase PondJet Instrucciones De Uso página 9

− Only plug the unit into a correctly fitted socket.
Safe operation
− Never operate the unit if either the electrical cables or the housing are defective!
− Do not carry or pull the unit by its electrical cable.
− Route all cables such that damage is excluded and nobody can trip over them.
− Never open the unit housing or its attendant components, unless this is explicitly required in the operating instruc-
tions.
− Only use original spare parts and accessories for the unit.
− Never carry out technical modifications to the unit.
− Only have repairs carried out by customer service points authorised by OASE.
− The power connection cables cannot be replaced. When the cable is damaged, the unit or the component needs to
be disposed of.
− Only operate the unit if no persons are in the water!
− Keep the socket and power plug dry.
Assembly and installation (A-E)
Unit assembly (A)
Insert the fountain holder (1) in the opening in the floating body (2). Turn in screw (4) including washer (5) into the
boring. Turn on the cap nut (6) including washer (5) on screw (4) from below.
Attention: Only hand tighten the screw or cap nut respectively.
Screw the pump type Classic 70 (3) on the fountain holder from below. Lower the fountain into the water.
Operation with a 12 jet fountain (B)
Remove the perforated disc (3) and the large O ring (4). Screw plug (1) and the small O ring (2) in again. Keep the
perforated disc (3) and the large O ring (4) for nozzles with a 1" connection (not part of our delivery).
Operation of the unit with a 1" nozzle ( C ) (not part of our delivery).
Place the perforated disc (3) and the large O ring (4) on the fountain (5). Screw nozzle (7) including the small O ring (2)
in the centre. Keep the plug (1) for operating the 12 jet fountain.
Operation of the unit with the Lunaqua 5 triple string.
Attention! Adhere to the instructions of use for the spotlight. Ensure that the spotlights are fully submerged.
Setting up the unit (D, E)
The unit floats on the water. To keep it in position, the cables (e.g. plastic cables, not included in our scope of delivery)
are fastened to the unit and either to the bank or to the pond bottom.
Anchoring the unit to the bank (D): Fasten the cables (2) on the 3 eyebolts in the floating body (1). Uniformly distribute
and fasten the free cable ends at the pond bank or basin rim. Attention! Ensure that the cables do not pose any dan-
ger. Secure the area around the fountain unit. Moderately tension the cables to allow for water level changes. Atten-
tion: Pull relieve the connection cable and protect the power plug from moisture!
Anchoring the unit to the pond bottom (E): Fasten the cables (2) on the 3 eyebolts in the floating body (1). Measure the
water depth. Cut the cables (2) to length = water depth + 1 m. Attach the anchor weight to the free cable ends (weight
approx. 20 kg). Position the fountain unit on the water and lower the weight to the bottom of the water. Attention! Do
not tension the cables to allow for water level changes. Attention: Pull relieve the connection cable and protect the
power plug from moisture!
- GB -
9