Signal Strength Indicator; Reset; Default Settings - Philips SCD570 Manual Del Usuario

When the rechargeable batteries are full, the
6
following happens:
• The third segment in the battery status
indicator stops flashing.
•
The display goes on for 4 seconds and
the message 'BATT FULL' appears on the
display.
Disconnect the parent unit from the electric
7
outlet to use it without cord.
• The battery status light is off when the
parent unit is used cordlessly on battery
power.
Note:
D
You can charge the parent unit when it is switched
off. In that case the battery status indicator is solid
green, but it gives no indication when the batteries
are fully charged.
Note:
D
If the rechargeable batteries run low very quickly,
they have reached the end of their life and you
have to replace them. To order new rechargeable
batteries, see chapter 'Ordering accessories'.

6.4 Signal strength indicator

• If the signal strength indicator has 4 bars, the
connection between the baby unit and the
parent unit is excellent.
•
If the signal strength indicator has 1 bar or
no bar at all, the transmission signal from the
baby unit is very weak or not available. Take
the parent unit closer to the baby unit to get
a better signal.

6.5 Reset

This function allows you to reset the parent unit
and the baby unit to the factory default settings.
Switch off the unit.
1
Press and hold the - button.
2
Switch on the unit again while holding
3
the - button.

6.5.1 Default settings

Parent unit
•
Language: English
•
Loudspeaker volume: 3
•
Microphone sensitivity: 3
•
Temperature alert: off
• 'Temperature low' alert: 14°C (57°F)
• 'Temperature high' alert: 35°C (95°F)
•
Temperature scale: Fahrenheit
•
Feed timer: 02:00
•
Feed timer: Stop
•
Clock: hidden
Baby unit
• Loudspeaker volume: 4
•
Nightlight: off
•
Lullaby: off (lullaby 1 selected)
13