Publicidad
Idiomas disponibles
Idiomas disponibles
C. CALORIE FUNCTION.-
This function counts up or down in
steps of one calorie, up to a maximum
of 999 calories.
Pressing the RESET key for more
than two seconds will reset all of the
values.
1. Press any key to switch the monitor
on.
2. Press the MODE key to start the
small
CAL
flashing.
3. Press the SET keys to select the
calories.
4. Begin the exercise and the calorie
value will begin the countdown, when
it reaches zero it will beep for 8
seconds,
advising
selected
calorie
reached, the calorie value will then
start counting upward.
D. ODOMETER.-
This function shows you the total
accumulated distance that you have
travelled throughout the exercises.
To reset the total distance travelled
(ODO), take the battery cover off (A),
Fig.1, and remove one of the batteries
to deactivate the monitor, then replace
the battery and the cover (A), Fig.1.
NOTE:
The
automatically reset whenever the old
batteries are replaced with new ones.
E. TIME FUNCTION.-
This function counts up or down in
steps
of
one second,
maximum of 99:59 seconds.
Pressing the RESET key for more
than two seconds will reset all of the
(CALORIE)
window
you
that
value
has
ODO
function
up to a
values.
1. Press any key to switch the monitor
on.
2. Press the MODE key to start the
small TIME window flashing.
3. Press the SET keys to select the
time.
4. Begin the exercise and the time
value will begin the countdown, when
it reaches zero it will beep for 8
seconds,
selected time has elapsed, the time
value will then start counting upward.
TROUBLESHOOTING GUIDE.-
Problem: The display comes on but
only the Time function works
Solution:
the
a.- Make sure that the connection
been
cable is connected.
Problem: The display does not come
on or the displayed segments are very
weak.
Solution:
a.- Check that the batteries are fitted
correctly.
b.- Check the battery charge.
c.- If they are run down change them
immediately.
Problem: Display segments of a
function read-out are not visible or
error
will
function appear.
Solution:
a.- Remove the batteries for 15
seconds and then refit them correctly.
b.- Check the battery charge If they
are run down change the batteries
c.- If the above steps do not help then
replace the electronic monitor.
7
advising
you
messages
for
that
the
a
particular
Publicidad
