Install Batteries - Bell console 500 Manual De Instrucciones

STEP 1
Computer — (Note: Battery is pre-installed) Remove the battery
cover from the bottom of the computer using a small coin.
Install the 3V battery with positive (+) pole facing the cover

Install Batteries

(Figure 1a). If the LCD shows irregular figures, take out the
battery and install again. This will clear and restart the computer's
microprocessor.
Battery is pre-installed.
Fig. 1a Fig. 1b
Transmitter Battery
Computer Battery (12V / VR22L)
)
(3V / CR 2032)
1028 /A 23
Wheel Transmitter - (Note: Battery is pre-installed) Install the 12V
battery in the wheel transmitter with the positive (+) pole facing
the battery cap. Re-install the cap with a small coin and be sure it
is tight to prevent moisture leakage (Figure 1b).