Hiltron security XR100 Manual Del Usuario página 12

XR100
2 SAMPLE INSTALLATION (in SLAVE mode)
XR100
Slave
C205
By
TM15
SK100
PROGRAMMING
System code
!
Enter the XR100 system code as indicated in section 3. This must be the same as the code used for the XR Series or
XR100 Master base unit with which it is to interact.
Function code
!
The function code for this installation is:
OPERATING IN SLAVE MODE
Green LED Off
On
Flashing
Red LED On
Flashing
Flash
BUZZER Sounds continuously for 3 seconds Disconnection of base unit (if enabled)
Sequence of beeps:
Intermittent
In this mode, the XR100 emits signals locally that are normally emitted by the base unit. Moreover, connecting the +12V
to contact C of relay 1 (terminal 6), with the base unit connected, will result in +12V on the NO contact of relay 1 (terminal 4) as
on the base unit terminal +int, while the NC contact of the same relay (terminal 5) will receive +12V with the base unit
disconnected, for controlling the green LED on the SK100.
Likewise, by connecting the +12V to contact C on relay 2 (terminal 3) we can control the self-powered sirens and piezo
sirens, as with the +S.A. and +Sir terminals on the base unit.
By sending +12V to input A, we can control the connection and disconnection of the base unit, while input B can be used
for a sensor that controls base unit zone 2.
12
SP31
TM92P
1 - 0 - 0 - 0 - 0 -
SK100
C205
0 - 0 - 0 - 0 - 0 - 0 - 0 - 1
System connected
System disconnected
Output time
Fault in sensor siren power supply
Base unit alarm active
Alarm memory
Base unit connection (if enabled) output time
Alarm signal
security
TDX16
TDC28
SP31
XR100
Slave