Operating Instructions
Series D9000 Spring Driven Hose Reels
Low Pressure Model Numbers:
D9200 OLPBW118
D9350 OLPBW118
D9299 OLPBW118
D9375 OLPBW118
D9300 OLPBW118
D9305 OLPBW118
Dimensions
See page 3 charts for size index number.
ORIGINAL INSTRUCTIONS
Noise is less than 70 dB(A)
INSTALLATION:
The swivel union is packed separately in the reel carton, use teflon tape to assure a satisfactory seal. A flexible hose
connection must be used between the hose reel inlet and the source of supply to prevent possible misalignment and
binding. Non flexible connections will void the warranty, pressure rating of inlet hose must be equal to or more than
the pressure rating of the reel. Consult Reelcraft for proper spring when installing reels above 16 ft.
LUBRICATION:
Hose reel spring and bearings are factory lubricated and require no further lubrication.
REPLACING HOSE: 1. Wind spool flange clockwise-facing swivel-until spring is tight.
2. Back off three turns and latch.
3. Insert hose through roller guide.
4. Connect hose fitting to female outlet ell.
ADJUSTMENTS:
To adjust spring tension, add or remove wraps of hose from the spool, one wrap at a time until desired tension is
obtained.
REPAIRS:
Extensive repairs should be performed only by an authorized serviceman or factory to avoid damage which may
void your warranty. Remove all spring tension before beginning disassembly process.
MODIFICATION:
Hose latching mechanism can be removed for constant tension applications.
Reelcraft International Inc. • Ph: +44 (0) 1536 406999 • Fax: +44 (0) 1536 406777
Unit 17 - Cronin Courtyard, Weldon South Industrial Estate, Corby - Northamptonshire NN18 8AG
europe@reelcraft.com • www.reelcraft.com/europe
D9399 OLPBW118
D9400 OLPBW118
D9450 OLPBW118
Size Index #
1
2
A
670 mm 670 mm
B
667 mm 667 mm
C
565 mm 565 mm
D
197 mm 343 mm
E
305 mm 451 mm
F
613 mm 613 mm
G
121 mm
98 mm
1. Models designed for fuel are coded with the prefix "F" i.e., "FD9400 OLP."
Check name plate on the reel before installing.
2. Do not use reel at higher pressures or temperatures than listed on the back
of this bulletin.
3. Remove all spring tension before beginning dissassembly process.
4. Reel spring motor case is permanently sealed. Any attempt to remove the
spring motor may cause serious injury.
SAFETY
Form# R835-696 Rev: 11/2019