G
I
8
17
7
7
L
-
Pull the spring retainer back (Figures G and H).
H
-
Position the jet needle in the throttle slide.
-
Mount the throttle slide with the jet needle (Figures I and J).
16
Ensure that the pin (16) of the spring retainer is engaged in the hole of the
throttle slide. Otherwise, there is a danger of the throttle cable wire coming
loose.
16
J
-
Position the throttle slide cover with the throttle slide in the carburetor
and tighten the screw (8) (3 Nm).
-
Turn the carburetor to the correct position (Figure K).
-
Tighten the screws (7).
-
Turn the air control screw (17) all the way clockwise and turn back out
1 1/2 rotations counterclockwise.
K
-
Adjust the play in the throttle cable (Figures L and M).
Play in throttle cable
M
3...5 mm
9