Unpacking Your Fan; Parts Inventory - Craftmade Saratoga SAR52CH Guia De Instalacion

1. Unpacking Your Fan.

Carefully open the packaging. Remove items from Styrofoam
inserts. Remove motor housing and place on carpet or Styrofoam
to avoid damage to finish. Do not discard fan carton or Styrofoam
inserts should this fan need to be returned for repairs.
Check against parts inventory that all parts have been included.

2. Parts Inventory.

e. remote control receiver. 1 piece
f. downrod and hanging ball. 1 piece
i. remote control cover. 1 piece
m. decorative downrod collar. 1 piece
n. canopy cover (in hardware pack). 1 piece
o. motor housing plate. 1 piece
q. large decorative band. 1 piece
t. threaded washer (pre-attached to light kit fitter).
v. finial plate (pre-attached to light kit fitter). 1 piece
w. finial (pre-attached to light kit fitter). 1 piece
x. small decorative band. 1 piece
IMPORTANT REMINDER: You must
use the parts provided with this fan for
proper installation and safety.
a. hanging bracket. 1 piece
b. canopy. 1 piece
c. yoke cover. 1 piece
d. arm support. 1 piece
g. arm. 4 pieces
h. wall plate.1 piece
j. faceplate. 3 pieces
k. wall control. 2 pieces
l. motor housing. 1 piece
p. blade hub. 1 piece
r. light kit fitter. 1 piece
s. glass housing. 1 piece
1 piece
u. fitter plate. 1 piece
y. blade arm. 5 pieces
z. glass shade. 1 piece
aa. blade.* 5 pieces
bb. hardware packs
up-light--6 x 15 watt max. candelabra base bulbs (included)
light kit--3 x 40 watt max. candelabra base bulbs (included)
a
b
f g
l
q
s
u
x
z
aa
*Blade drawings in this manual
are representative only
page 2
c
e
d
h i
j
k
m n
o p
r
t
v
w
y
bb
bulbs required:
- 1 1
- 2 2
ON/ DIM
OFF
w/remote
w/ wall
control