Publicidad
BUILDING BASICS
Getting Started:
1
To begin your model, find the
and follow
the numbers. Each piece has its own shape and
color. Just look at the pictures, find the pieces
in your set that match and then connect them
together. Try to face your model in the same
direction as the instructions while you build.
Faded colors show you this section is already
built. You'll want to connect the new section to
the place where the arrows are pointing (not all
connections have arrows).
3
1
2
4
1
3
FCC Statements:
WARNING: Changes or modifications to this unit not expressly approved
by the party responsible for the compliance could void the user's right to
operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference received, including interference
that may cause undesired operation. This model is tested to comply with
FCC standards - FOR HOME OR OFFICE USE.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy, and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures: (1) Reorient or relocate the receiving
antenna. (2) Increase the separation between the equipment and receiver.
(3) Consult the dealer or an experienced radio/TV technician.
This Class B digital apparatus complies with Canadian ICES-003.
Connectors:
There are blue and gray connectors with special
long slots. They slide together as you see in the
pictures. Push these parts together until you hear
a "click".
Parts Count:
Before you start building, be sure to compare the
parts in your set with the parts listed here. If anything
is missing, call or write to us using the information
on the back cover. We're here to help!
Go to
Track:
Always connect the track top side to top side
throughout the build. Attach the connectors to the
bottom side of the track exactly as shown. Be sure
to push the connectors on firmly until they "click".
Spacers:
There are places in your model where you need to
add blue and silver spacers. Be sure to use the
right color and count them carefully.
for Instruction Updates
Top side of track
Track may look like this.
Graphic
Panel:
See page 50 for
attaching panel
to the model.
3
Publicidad
