Naxa NPD-1004 Manual De Operación página 11

BATTERY INSTALLATION (REMOTE CONTROL)
Battery installation:
1. Press the tab on the battery door and lift it off.
2. Ins two (2) x AAA size batteries (not included) into the battery
compartment as the Figure on right with the proper polarity
markings inside battery compartment.
Battery Precautions:
Follow these precautions when using a battery in this device:
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as indicated in
the battery compartment. A reversed battery may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc)
or old batteries with fresh ones.
4. If the batteries in the device are consumed or the device
of time, remove the
batteries to prevent damage or injury from possible battery leakage.
5. Do not try to recharge the battery not intended to be recharged; it can overheat and rupture.
(Follow battery manufacturer's directions).
6. Do not dispose of battery in
7. Clean the battery contacts and also those of the device prior to battery installation.
Remote Control Working Range:
Remarks:
1. When there is an obstacle between the unit and the transmitter, the transmitter may not operate.
2. When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light shines on the
remote control of the unit, the remote operation may be unstable.
fire. Battery may explode or leak.
15 Feet (5M)
11
not to be used for a long period
POWER