Naxa NPD-1004 Manual De Operación página 5

to this product, ask the service technician to
perform safety checks to determine that the
product is in proper operational condition.
23 ) Wall or ceiling mounting
The product should be mounted to a wall
or ceiling only as recommended by the
manufacturer.
24 ) Damage requiring service
Unplug this product from the wall outlet and
refer service to qualified service personnel
under the
following conditions.
a ) When the power-supply cord or plug is
damaged.
b ) If liquid has been spilled or objects have
fallen into the product.
c ) If the product has been exposed to rain or
water.
d ) If the product does not operate normally
by following the operating instructions. Adjust
only those controls that are covered by the
operating instructions, as an adjustment of
other controls may result in damage and will
and require extensive work by a qualified
technician to restore in the product to its
normal operation.
e ) If the product has been dropped or the
cabinet has been damaged.
f ) When the product exhibits a distinct change
in performance-this indicates a need for
service.
25 ) Note to CATV system installer
This reminder is provided to call the CATV
system installer's attention to Article 820-40
of the NEC that provides guidelines for proper
grounding and, in particular, specifies that
the cable ground shall be connected to the
grounding system of the building, as close to
the point of cable entry as practical.
NOTE: Refer all servicing to qualified service
personnel Servicing is required when the unit
has been damaged in any way such as the
following: the power-supply cord
has been damaged, liquid has been spilled
into unit, the unit has been exposed to rain or
moisture, the unit has been dropped or the unit
does not operate normally.
NOTES ON HANDLING:
● When shipping the unit, always use the
original shipping carton and packing materials.
For maximum protection, repack the unit as it
was originally packed at the factory.
● Do not use volatile liquids, such as insect
near the unit. Do not leave rubber or
spray,
plastic products in contact with the unit for a long
time. They will leave marks on the finish.
● The top and rear panels of the unit
may become warm after a long period of use.
This is normal and not a malfunction.
● When the DVD player is not in use, be sure
to remove the disc and turn off the power.
NOTES ON LOCATING THE DVD PLAYER:
When you place this unit near a TV, radio or
VCR, the playback picture may become poor
and the sound may be distorted. In this case,
move the unit away from the TV, radio or VCR.
NOTES ON CLEANING:
Use a soft, dry cloth for cleaning
● For stubborn dirt, soak the cloth in a weak
detergent solution, wring well and wipe. Use a
dry cloth to wipe it dry. Do not use any type of
solvent, such as thinner and benzene, as they
may damage the surface of the unit.
● If you use a chemical-saturated cloth to clean
the unit, follow that product's instructions.
Wa r n i n g : C l e a n i n g a n d a d j u s t m e n t o f
lenses and /or other components of playback
mechanism should be performed by a qualified
service technician.
NOTES ON MOISTURE CONDENSATION:
Moisture condensation damages the DVD
player.
Please read the following carefully.
● Moisture condensation occurs, for example,
or plug
when you pour a cold drink into a glass on a
warm day. Drops of water f m on the outside
5