Power Source - Naxa NPD-1004 Manual De Operación

POWER SOURCE

There is a built-in DC 7.4V Lithium-ion rechargeable battery.
Charging by the AC/DC adaptor:
1. Connect the small plug from the supplied AC/DC Adapter to the DC IN Jack on the unit.
2. Connect the AC/DC Adapter to the wall outlet with AC100-240V~; 50/60Hz.
3. During charging, the charging indicator will turn red, when charging
NOTES:
Your battery will last longer if you follow these simple guidelines for caring and storing it.
A.
Recharge and store the device within the temperature range of 5°C~35°C (40°F~95°F).
B.
Do not overcharge (longer than 24 hours). Excessive charging or
battery's life.
C.
Battery life naturally shortens slowly over time.
The rechargeable battery
D.
Charging by the car adaptor:
1. Connect to the cigarette lighter socket of a vehicle that has a 12V battery as
It is NOT compatible with a vehicle that has a 24V battery.
2. This is a special negative grounded
Car Adapter. Using this Car Adapter
with a plus grounded car can cause
malfunction.
3. Do NOT plug in the Car Adapter until
the car ignition is turned on.
4. Disconnect the Car Adapter from the
cigarette lighter and the unit after use.
To DC IN Jack on the unit
Recharge it
in this product is not replaceable.
12
as follows:
, it will turn green.
discharging may shorten the
the figure below.
To the cigarette
lighter socket