Kohler Purist K-T14428 Guia De Instalacion página 4

o
l
r a
r a r
or a r
o
al
o
2. Installation on Finished Deck or Rim
NOTE: For installation on a rough (unfinished) deck, proceed to Installation
on Rough (Unfinished) Deck.
Use 1/2" nominal, 5/8" O.D. copper tubing. Cut two pieces of tubing to a
length of 2–7/8" (7.3cm). Cut one piece of tubing to a length of 2–3/8"
(6cm) for the spout supply.
IMPORTANT! Leave the protective sleeve on the spout supply tube until
the spout is installed to protect the O-ring sealing surface.
Install Spout Supply Tube
Slide a brass washer from the bottom of the spout supply tube over the
threads until the washer reaches the supply tube shoulder.
Insert the spout supply tube through the mounting hole from the top of the
deck/rim. Ensure that the flat portion of the washer faces forward. The
supply tube will be suspended by the washer.
Slide a brass washer onto the spout supply tube from the bottom and
thread the mounting nut. Tighten the nut.
NOTE: Do not use the supplied wood screws for installation on finished
deck or rim.
Install Valve Bodies
Thread one mounting nut, flange side up, onto each valve body.
NOTE: Rims less than 1/4" (6mm) thick require two rubber washers in the
following step; other installations require one rubber washer.
1016271-2-A
l
o l r
r
"
Co r
ol
o
l ol
4
1"
Collar
ra a
ol r
Col
1 " 1
r
"
r
Co r
Kohler Co.
r
l