Expected Coverage - DESA Specialty Products JourneyMan HD-9250 Manual Del Usuario

Adjustments Continued . . .
❒
Loosen the wing screws, estimate the direction to aim the sensor and tighten
the wing screws just enough to hold the sensor in place.
❒
Walk through the coverage area noting where you are when the lights turn
on. Loosen the wing screws and readjust the sensor as necessary. Tighten the
wing screws (finger tight) when you are satisfied with the coverage direc-
tion. Keep the sensor at least 1 inch (25 mm) from lamps and keep the
controls on the bottom.
❒
Adjust SENSITIVITY as needed to increase or decrease the range. Too much
sensitivity may increase false triggering.
❒
Set the amount of TIME (1, 5 or 20 minutes) you want the lights to stay on
after motion is detected at night.
❒
If you need to detect objects more than 70 feet (21 m) away, turn Range
Boost on.
❒
Replace the rubber cover to protect controls.
The sensor is less sensitive to motion directly
towards it, most sensitive to motion across its
field of view.
Motion
Sensor
Least Sensitive

Expected Coverage

When mounted 8 feet (2.4 m) from the ground, you
may expect the range shown below. If mounted much
higher the sensor may miss objects near the ground.
If mounted much lower the sensor range may be
reduced.
Motion
Most Sensitive
-10-
Maximum Range
8 ft.
(2.4 m)
Aim Sensor Down
for Short Coverage
Aim Sensor Out for
Long Coverage
70 ft. 100 ft.
(21 m) (30,5 m)
(Boosted)
595-5658-07