Universal Adaptor; Standard Wiring - DESA Specialty Products JourneyMan HD-9250 Manual Del Usuario

Universal Adaptor

If you are mounting the JourneyMan
small rectangular box, you will need to use the
universal adaptor as shown below. Other boxes
may require the adaptor adjusted differently.
If you are using a standard octagon box, the adap-
tor is probably not required.
Use these holes and the #8-
32 X 3/8" (10 mm) screws
provided to secure the fixture.
#6-32
screw
Horizontal Box
Use these holes
and the #8-32 X
3/8" (10 mm)
screws provided
to secure the
fixture.
If the mounting holes in the fixture base still do
not line up with the threaded holes in the univer-
sal adaptor, you can (1) remove the adaptor and
flip it over or (2) remove the other pair of knock
outs in the fixture base.
®
fixture to a
screws
Vertical Box
#6-32
screw
CAUTION: If you have not already turned the
power off at the breaker or fuse, do so now.
Make sure the gasket is in place before connect-
ing any wires. You may find it convenient to use
the wire hanger provided to hold the fixture to the
junction box during the wiring process.
Connect the junction box wires to the fixture wires.
Twist together and secure with wire connectors.
CAUTION: If you are not controlling additional
fixtures from your JourneyMan
connect the RED wire.
Junction
Green ground
wire to
junction box
ground wire
#6-32
RED, not
used in most
applications
-6-

Standard Wiring

®
Box
fixture, DO NOT
White to
White
Black to
Black
Gasket
595-5658-07