Controlling Non-Motion Sensing Fixtures - DESA Specialty Products JourneyMan HD-9250 Manual Del Usuario

Controlling Non-Motion Sensing
Fixtures
❒
When wiring to additional standard fixture
only: Strip the motion sensor's red wire and
connect to the standard light's black wire.
Connect all white wires together. Total fixture
ratings must not exceed 1000W (8.3 A).
NOTE: All wiring between fixtures should be run
in accordance with the National Electrical
Code through conduit or another acceptable
means. Contact a qualified electrician if
there is any question as to the suitability of
the system.
595-5658-07
BLACK from
Switch to
BLACK from
JourneyMan
WHITE from Line
to WHITE from
JourneyMan ®
Wiring to a Motion Light & Standard Fixture
❒
This fixture is provided with a sensor rated
for 1000W. Since the fixture is only rated
300W, 700W of additional load may be con-
trolled by this sensor.
❒
When determining what a fixture is rated for,
do not simply look at the rating on the lamp in
the fixture. Look at the marking which speci-
fies the maximum lamp wattage for which the
fixture is suitable.
❒
Once you have selected the fixtures to be con-
nected and determined their maximum ratings,
add these ratings up. For instance, if you have
3 fixtures rated 100W, 150W, and 75W respec-
tively, you have a total load of 325W.
RED from
JourneyMan
®
BLACK from
Fixture
WHITE from Line
to WHITE from
Fixture
-7-
®
to
(Standard)