X-LITE X-1004 Seguridad E Instrucciones página 3

CHOOSING THE HELMET
Size:
- In order to determine the correct helmet size, try on helmets of different sizes and
best the shape of your head and which you feel firm once
- Should the helmet be too big, it may slide down covering the eyes or turn slowly to the side while riding.
- Keep it on for a few minutes and make sure there are no points of extreme pressure
headache.
Taking off the helmet:
- With the helmet on and the strap securely fastened, try to take the helmet off as shown in Fig. A. In case of
accident the different forces at stake and their various directions may result in helmet rotations or they may
even cause the helmet to slip off if it is not
- The helmet should not rotate nor move on the head and should not slide off. Should
strap length or change helmet size. Repeat test.
Retention System:
- The retention system (strap) is factory-adjusted at a standard length. Before use, check that it is correctly pre-
adjusted.
- Make sure the strap is properly fastened and tightened so as to keep the helmet firmly in place. Anyway, before
riding, make sure that the strap is well fastened
being uncomfortable.
- The correct strap tension should allow normal breathing and swallowing, but without
finger between strap and throat.
- Attention: the button which may be present on the strap only prevents its end from
been fastened properly.
VISOR
- If the visor is damaged or deeply scratched causing reduced visibility, this means that the protective treatment
is probably damaged so the visor is to be replaced.
- The visor can be used only for the intended helmet model.
- Do not paint nor apply stickers.
CHOOSING THE HELMET
Size:
- In order to determine the correct helmet size, try on helmets of different sizes and
best the shape of your head and which you feel firm once
- Should the helmet be too big, it may slide down covering the eyes or turn slowly to the side while riding.
- Keep it on for a few minutes and make sure there are no points of extreme pressure
headache.
Taking off the helmet:
- With the helmet on and the strap securely fastened, try to take the helmet off as shown in Fig. A. In case of
accident the different forces at stake and their various directions may result in helmet rotations or they may
even cause the helmet to slip off if it is not
- The helmet should not rotate nor move on the head and should not slide off. Should
strap length or change helmet size. Repeat test.
Retention System:
- The retention system (strap) is factory-adjusted at a standard length. Before use, check that it is correctly pre-
adjusted.
- Make sure the strap is properly fastened and tightened so as to keep the helmet firmly in place. Anyway, before
riding, make sure that the strap is well fastened
being uncomfortable.
- The correct strap tension should allow normal breathing and swallowing, but without
finger between strap and throat.
- Attention: the button which may be present on the strap only prevents its end from
been fastened properly.
VISOR
- If the visor is damaged or deeply scratched causing reduced visibility, this means that the protective treatment
is probably damaged so the visor is to be replaced.
- The visor can be used only for the intended helmet model.
- Do not paint nor apply stickers.
worn and fastened, thus ensuring a great comfort.
securely fastened.
under the chin, as close as possible to the throat, but without
worn and fastened, thus ensuring a great comfort.
securely fastened.
under the chin, as close as possible to the throat, but without
choose the one which suits
that may cause pain or
the contrary happen, adjust
leaving the space of a
flapping once the strap has
choose the one which suits
that may cause pain or
the contrary happen, adjust
leaving the space of a
flapping once the strap has