General Notes - Lutron PHPM-WBX-DV-WH Instrucciones De Instalación

General Notes

WARNING. Shock Hazard. May result in
serious injury or death. Always turn OFF the
circuit breakers or remove the main fuses
from the power line before doing any work.
More than one disconnect may be required
to de-energize this device. Disconnect all
power sources before servicing unit.
• This power module must be installed by a qualified
electrician in accordance with all applicable
regulations.
• Improper wiring can result in personal injury,
damage to the interface, or damage to other
equipment.
Notes
• Up to three power modules per circuit.
• The power module must be mounted with arrow
facing upward to ensure adequate cooling.
• Dimmed magnetic low-voltage transformers: To
avoid excessively high current flow that can cause
transformer overheating and failure, observe the
following:
(a) Do not operate the power module with all of the
lamps removed or with any lamps inoperative.
(b) Replace any burned out lamps immediately.
(c) Use only transformers that incorporate thermal
protection or fused primary windings.
• These power modules contain circuitry that will
shut down the output if it is overloaded. To correct
the problem, turn off power and reduce the load to
the specified rating and/or ensure proper air flow
before re-applying power.
Note: Plastic faceplate must be installed on
module for normal operation (all models).
2
Phase-Adaptive Power Module with 3-Wire Fluorescent Input