Wiring
Single Power Feed for Control and Load Sides
The power module may be on the same circuit as the control unit only if the total load does not exceed the
rating of the branch circuit breaker in accordance with local and national electrical codes.
Circuit breaker
120 V~ - PHPM-WBX-120-WH
PHPM-WBX-DV-WH
220–277 V~ - PHPM-WBX-277/DV
L / H
N
Load
Legend
L/H
Line/Hot
N
Neutral
SH
Switched Hot
DH
Dimmed Hot
Ground
Not Used
L / H
N
L/H
N
DH
Notes
• For three-way or multi-location wiring: All switches and/or
accessory dimmers must be on the line/feed side of the dimmer
for proper operation. See the wiring diagram on the Specification
Submittal at www.lutron.com (Lutron P/N 369358).
• For wiring multiple power modules: Up to 3 power modules total
may be wired to a single control device. See the wiring diagram on
the Specification Submittal at www.lutron.com (Lutron P/N 369358).
Phase-Adaptive Power Module with 3-Wire Fluorescent Input
3-wire
fluorescent
dimmer
SH
(red wire)
Cap off
DH
(yellow or orange wire)
Zone in
Control Neutral
5