Skin Sensitivity Test - Me Smooth Guia Del Usuario

using
7
8

skin sensitivity test

If you are using the system for the first time or on a new body area, choose a
small area close to the area you intend to treat, for the purpose of performing
a skin sensitivity test. Use the LOW
below but make sure to emit only 2-3 pulses. After the skin test, wait 30 minutes
and check your skin for any reaction. If after 30 minutes the skin appears normal
and there is no redness or other skin reaction, then you are ready to perform a
full treatment.
13 EN
7. Set the desired energy level, Low Medium or High.
8. The cartridge is pre-loaded with pulses for your
use (100%). The cartridge indicator shows the percentage
of pulses remaining as you use the system. When the
cartridge is left with 5% only, the Empty indicator starts
blinking. When the indicator's light is constant, cartridge is
empty and there is a need to replace it.
level. Follow the treatment instructions