Treating With Me - Me Smooth Guia Del Usuario

treating with
4
5
correct incorrect
6
skin surface
7
Step 7. After every flash, glide the applicator slowly to the next neighboring spot
over the skin by moving it in one continuous, slow motion.
Avoid overlap between adjacent pulses.
Note: The applicator will automatically turn itself off if it is not in use for 30
seconds. To turn the applicator back on, press the
located on the applicator
Step 1. Shave any visible hair in the area you want to treat.
Shaving hair in the treatment areas should minimize
the discomfort felt from the flashes. Make sure that the
accessories protective cap (provided) is inserted. The
system will not work if the protective cap is not in place.
Step 2. Clean your skin and dry it with a towel.
Step 3. Turn on the me system. Select the Low energy level
setting. The device will not work if you do not select an
setting. If there is little or no discomfort or reaction, then
raise the energy level to the Medium or High setting.
Step 4. Remove the applicator from the base.
Step 5. Press the
activation button located on the
applicator. The button will turn blue, and you will hear the
fan inside the applicator.
Step 6. Gently place the applicator on your skin, so that the
two RF chrome contact bars are in complete contact with
the skin. The me will emit pulses.
Note: The applicator will not work unless both RF
chrome contact bars are touching the skin
activation button
EN 14