Travel With Me; Troubleshooting - Me Smooth Guia Del Usuario

travel with
The me system is designed with universal voltage. That means that you can use
the system all over the world. You will need to use an adaptor for the plug, since
electrical wall outlets vary by country. Make sure that me system does not get
wet while traveling and do not use it in a wet environment. A travel bag may be
purchased separately at www.mepower.com.

troubleshooting

Indicator
No lights are on
All energy setting
buttons are blinking
(High-Medium-Low)
activation button
on the applicator is
blinking
Error light is on
No flashes are coming
out
19 EN
What does it mean
Device
Power cable is not connected Connect power cable
No energy level was
selected
energy level was selected
but activation button was
not pressed yet
Need to reset the system
1. RF chrome skin contact
bars not in contact with the
skin in treatment area
2. activation button is not
pressed or energy level
was not selected
How to react
Select an level. The applicator fan will
start blowing indicating that the cartridge
is active
Press the activation button. The
applicator fan will start blowing indicating
that the cartridge is active
Reset the system by turning it off and on
again. If problem persists, disconnect
power cord and wait until all lights are off
(several seconds). Then reconnect the
power cord and turn on system. If error light
is still on, try moving to a cooler area with a
room temperature of less than 30ºC/ 86ºF
and restart the system
In order for the system to flash pulses, make
sure all 3 conditions are met:
selected , activation button is pressed,
RF chrome skin contact bars are in contact
with skin
level