Dual Assignment Instructions (Long Button Press); Dual Assignment Legend; Resetting The Bx-Gm8 - Axxess BX-GM8 Guia Del Usuario

Steering wheel audio control extra settings

Dual assignment instructions (long button press)

The BX-GM8 has the capability to assign (2) functions to a single button, except
Volume-Up and Volume-Down. Follow the steps below to program the button(s)
to your liking.
Note: Seek-Up and Seek-Down come pre-programmed as Preset-Up and
Preset-Down for a long button press.
1) Turn on the ignition but do not start the vehicle.
2) Press and hold down the steering wheel control button that you want to assign
a long press function to for about (10) seconds, or until the L.E.D. flashes
rapidly. At this point release the button; the L.E.D. will then go solid.
3) Press and release the Volume-Up button the number of times corresponding
to the new button number selected. Refer to the Dual Assignment Legend. The
L.E.D. will flash rapidly while the Volume-Up button is being pressed, and then
go back to a solid L.E.D. once released. Go to the next step once the Volume-Up
button has been pressed the desired number of times.
Caution: If more than (10) seconds elapses between pressing the Volume-Up
button, this proce-dure will abort, and the L.E.D. will go out.
4) To store the long press button in memory, press the button that you assigned a
long press button to (the button held down in Step 2). The L.E.D. will now go off
indicating the new information has been stored.
Note: These steps must be repeated for each button you would like to assign a
dual purpose feature to. To reset a button back to its default state, repeat Step
1, and then press the Volume-Down button. The L.E.D. will go off, and the long
press mapping for that button will be erased.
BX-GM8

Dual assignment legend

1. Not allowed
2. Not allowed
3. Seek-Up/Next
4. Seek-Down/Prev
5. Mode/Source
6. ATT/Mute
7. Preset-Up
8. Preset-Down
9. Power
* Not applicable in this application

Resetting the BX-GM8

1. With the radio on, turn the potentiometer:
Note: Before proceeding, remember the position the potentiometer is at.
Left......hold for 3 seconds
Right.....hold for 3 seconds
Left......hold for 3 seconds
Back to the initial position
2. The L.E.D. in the BX-GM8 will pause for a moment, then flash fast, and then
flash slowly up to (16) times. Pay close attention as to how many slow flashes
there are. This will help in troubleshooting, if need be.
7
10. Band
11. Play/Enter
12. PTT
13. On-Hook
14. Off-Hook
15. Fan-Up
16. Fan-Down *
17. Temp-Up *
18. Temp-Down *