Attach The Guard; Assemble The Shaft; Attach The Auxiliary Handle; Install The Battery Pack - GreenWorks STF309 Manual Del Operador

Ocultar thumbs Ver también para STF309:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Push the edge guide onto the trimmer head until it
engages in the slots.
2. The edge guide can be flipped up for storage.
7.3

ATTACH THE GUARD

Figure 3.
WARNING
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a
Phillips head screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw
holes on the trimmer head.
4. Tighten the screws.
7.4

ASSEMBLE THE SHAFT

Figure 4.
1. Push the lower shaft into the upper shaft.
2. Align the groove on the lower shaft with the
prominent part in the upper shaft.
3. Slide the shafts until the release button locks into
the positioning hole in the upper shaft.
4. Tighten the coupler.
7.5

ATTACH THE AUXILIARY HANDLE

Figure 5.
1. Remove the knob from the handle.
2. Attach the auxiliary handle on the shaft.
3. Set the auxiliary handle in the comfortable position.
4. Tighten the auxiliary handle with the knob.
7.6

INSTALL THE BATTERY PACK

Figure 6.
WARNING
If the battery pack or charger is damaged, replace
the battery pack or the charger.
Stop the machine and wait until the engine stops
before you install or remove the battery pack.
Read, know, and do the instructions in the battery
and charger manual.
The battery is shipped at 30% charge. Charge the
battery fully before first use.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
English
7.7

REMOVE THE BATTERY PACK

Figure 6.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
8

OPERATION

Before you operate the machine, read and understand
the safety regulations and the operation instructions.
Be careful when you operate the machine.
8.1

START THE MACHINE

Figure 7.
1. Pull back on the lock-out button and pull the trigger.
8.2

STOP THE MACHINE

Figure 7.
1. Release the trigger to stop the machine.
8.3

OPERATION TIPS

Figure 7.
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Do these tips when you use the machine
Keep the machine connected to the correctly worn
harness.
Keep a firm hold with the two hands on the machine
while you operate the machine.
Cut tall grass from the top down.
If grass winds around the trimmer head:
Remove the battery pack.
Remove the grass.
8.4

CUTTING TIPS

Figure 8.
Tilt the machine toward the area to be cut. Use the
tip of the cutting line to cut grass.
Move the machine from right to left to prevent
thrown debris toward the operator.
Do not cut in the dangerous area.
5

IMPORTANT

WARNING
WARNING
WARNING
EN

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido