Clean The Machine; Replace The Spool; Replace The Cutting Line; Transportation And Storage - GreenWorks STF309 Manual Del Operador

• Remove the battery pack.
• Cool the motor.
• Store the machine in cool and dry place.
• Use correct clothing, protective gloves and safety
glasses.
9.2

CLEAN THE MACHINE

• Clean the machine after use with a moist cloth
dipped in neutral detergent.
• Do not use aggressive detergents or solvents to
clean the plastic parts or handles.
• Keep the trimmer head free of grass, leaves, or
excessive grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
• Do not spray water onto the motor and electrical
components.
9.3

REPLACE THE SPOOL

Figure 13 - 14.
1. Push the tabs on the sides of the trimmer head at
the same time.
2. Pull and remove the spool cover.
3. Remove the spool.
4. Replace with a new spool.
NOTE
Make sure that the cutting line is in the guide slot on
the new spool, and is extended approximately 5 in.
before you install the new spool.
5. Put the end of the cutting line through the eyelet.
6. Push the tabs and install the spool cover onto the
spool housing.
7. Push the spool cover until it clicks into position.
9.4

REPLACE THE CUTTING LINE

Figure 15.
NOTE
Remove the remaining cutting line on the spool.
NOTE
Use only with the nylon cutting line of 0.065" (1.65
mm) diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend one end of the line 1/4 of an inch (6.35mm) .
3. Insert the line into the anchor hole of the spool.
4. Wind the cutting line around the spool tightly in the
indicated direction.
5. Put the cutting line in the guide slot.
English
6. Do not wind the cutting line beyond the edge of the
spool.
10 TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
tranportation and storage.

10.1 STORE THE MACHINE

• Remove the battery pack from the machine.
• Make sure that children cannot come near the
machine.
• Keep the machine away from corrosive agents such
as garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine
for any damage.
11

TROUBLESHOOTING

Problem Possible Cause
The ma- No electrical
chine does contact between
not start the machine and
when you the battery pack.
push the
trigger.
The battery pack
is depleted.
The lock-out but-
ton and trigger
are not pushed
at the same
time.
7
WARNING
Solution
1. Remove battery
pack.
2. Check contact and
install the battery pack
again.
Charge the battery
pack.
1. Pull the lock-out but-
ton and hold it.
2. Pull the trigger to
start the machine.
EN