Operation; Engine Stop Lever; Wheel Drive System; Stopping The Engine - Briggs & Stratton BRUTE 7800743 Manual Para El Operador

Operation

Engine Stop Lever

Release the engine stop lever (A, Figure 12) and the engine
and the blade will automatically stop. To run the engine, hold
the engine stop lever in the Operating position (B).
Before you start the engine, operate the engine stop lever
several times. Make sure the cable moves easily.
B
Figure 12: Operating the engine stop lever

Wheel Drive System

The mower has a wheel drive system. Operate the drive
system as follows.
1. Hold the engine stop lever (A, Figure 12) in the
Operating Position (B).
2. Slowly pull the drive lever (A, Figure 13) back. The
drive system is now engaged. To increase ground
speed, slowly pull the drive lever farther back. To
decrease ground speed, slowly release the drive lever.
3. To disengage the drive system and stop the engine,
completely release the engine stop lever.
4. To disengage only the drive system, release the drive
lever. The drive system will disengage but the engine
will continue to run.
Note: When the drive system is disengaged on a new unit, it
is possible for the wheels to rotate if lifted off the ground.
This is normal and will stop after one or two hours of opera-
tion.
12
A
Figure 13: Operating the wheel drive system

Stopping the Engine

To stop the engine, release the engine stop lever. Disconnect
the wire from the spark plug to prevent the engine from
starting.
Before you start the engine, check the engine stop cable.
Make sure the engine stop cable is assembled correctly.
Before you operate the unit, replace a bent or damaged
engine stop cable.
WARNING: For safe operation, the drive
system must immediately disengage when the
drive lever is released. If the drive system
does not disengage correctly, do not operate
the mower until the drive system is adjusted
or repaired by an authorized service center.
A
www.brutepower.com