Preparing The Mower For Storage - Briggs & Stratton BRUTE 7800743 Manual Para El Operador

WARNING: Do not attempt mowing operations
while using the washout port.
WARNING: Do not attempt to look under or
reach under the mower housing for any reason
while using the washout port. Serious injury
can result.

Preparing the Mower for Storage

WARNING: Do not remove gasoline while
inside a building, near a fire, or while you
smoke. Gasoline fumes can cause an
explosion or a fire.
1. Drain the fuel tank.
2. Let the engine run until it is out of gasoline.
3. Drain the oil from the warm engine. Fill the engine
crankcase with new oil.
4. Remove the spark plug from the cylinder. Pour one
ounce of oil into the cylinder. Slowly pull the recoil-start
grip so that the oil will protect the cylinder. Install a new
spark plug in the cylinder.
Figure 20: Washout port
5. Clean the dirt and debris from the cylinder cooling fins
and the engine housing.
6. Clean the bottom of the mower housing.
7. Make sure the grass bag is empty of grass. Grass
remaining in the bag during storage will damage the
bag.
8. Completely clean the mower to protect the paint.
9. Fold the handles (if desired).
CAUTION: Be careful when you fold or raise the handle. Do
not damage the cables. A cable that is bent will not work
correctly. Before you use the unit, replace a bent or damaged
cable.
10. Put the unit in a building that has good ventilation.
Maintenance
A
19