Publicidad
14
14
BLACK 9/16" LARGE HEAD SCREW
(24 used in this step)
E
NAIL
(16 used in this step)
Carefully turn your unit over onto its front edges. Lay the LARGE BACKS (G) over your unit.
Fasten the LARGE BACKS (G) to the BACKS (E and F). Use twenty-four BLACK 9/16" LARGE HEAD SCREWS (1S). Fasten
the top and bottom edges of the LARGE BACKS to your unit using the NAILS (1N).
NOTE: Position perforations as shown. Perforations have been provided for access through the BACK. Carefully cut out the holes
needed.
Push the FOOT (23E) into the hole in the BOTTOM (D).
Page 18
1S
G
1N
www.sauder.com/services
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
G
F
The perforations
should be here.
The perforations
should be here.
E
D
23E
414721
Publicidad
