Pinnacle Climate Remington REM-L180ALT-F Manual Del Usuario página 15

WARNING
Before beginning assembly or operation of this heater, ensure all parts are present. Check the parts against
the package contents list. If any part is missing or damaged, do not attempt to assemble, install, or operate
the heater. Contact customer service for replacement parts.
Estimated Assembly Time: 1 to 2 hours
Tools Required for Assembly (not included, unless otherwise stated):
Before installing the heater, ensure you have the following:
• Hardware package (included)
• Approved flexible gas hose if allowed by local codes
• Sealant (resistant to natural or propane/LP gas)
• Electric drill with 3/16" drill bit
• Phillips screwdriver
• External regulator (supplied by installer if required)
• Piping (check local codes)
• Equipment shutoff valve
• Test gauge connection
• Sediment trap
• Tee joint
• Pipe wrench
• 3/8" NPT to 3/8" flare fitting
UNPACKING
1. Remove logs, grate, and burner base assembly from carton.
NOTE: Do not pick up the burner base assembly by the burners. This could damage heater. Only handle the
base assembly by its frame.
2. Remove all protective packaging used on the logs and heater.
3. Inspect the items for shipping damage. If you notice any damage, contact the dealer where the heater
was purchased.
©2017 Pinnacle Climate Technologies
Installation (cont.)
Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this heater may result in property damage or personal injury.
15 Vent-Free Gas Log Heater User Manual