Charging The Batteries; Preparing The Remote Controller - DJI MATRICE 200 Serie Guia De Inicio Rapido

Using Matrice 210/Matrice 210 RTK
1. Downloading DJI Assistant 2
Download and install DJI Assistant
http://www.dji.com/matrice-200-series
Ensure that the built-in DJI GO 4 app and DJI Pilot app are working normally. This manual uses the DJI GO 4 app as an example.
First-time activation requires your DJI account and an internet connection.
Internet
DJI Assistant 2 is only available for Windows 7 (or later) or OS X 10.11 (or later).

2. Charging the Batteries

Press the release button and open the corresponding charging port cover.
Insert the Intelligent Flight Battery into the charging port to begin charging.
Be sure to press the release button when removing fully charged batteries.
1
A
2
Using the IN2CH Charging Hub, charging time
is approximately.
TB50-M200: 1 hour and 30 min (two batteries)*
TB55: 2 hours and 33 min (two batteries)*
DO NOT charge TB50-M200/TB55 and WB37 batteries simultaneously.
When charging is complete, the LED lights on the Intelligent Flight Battery will turn off, and the LED on the Charging Hub will turn solid green.
When charging is complete, the display on the remote controller will show 100%.
The Charging Hub will sound an alert when the battery has been fully charged. The alert can be turned on or off by toggling the switch under the hub.
Connect the Intelligent Flight Batteries to the aircraft and power them on. If battery temperature is lower than 15° C, the system will auto heat the batteries to maintain
a temperature between 15° and 20° C.
Pairing Intelligent Flight Batteries is recommended. This can be done with the DJI GO 4 app.

3. Preparing the Remote Controller

Mounting Monitor and Remote Controller Batteries
CrystalSky monitors and the Cendence remote controller
use the same batteries.
Put the battery into the Battery Slot, then slide it to the end
until you hear a click.
Press the Battery Release Button before removing the battery.
Press the Battery Level Button once to check the battery level.
Mounting the Monitor to the Remote Controller
A
B
Ensure that Part B is
unlocked. Connect Part
B to Part A.
4
2 on your computer via the website link below:
TM
B
Charging Time: Using the WCH2 Charging Hub,
2 hours and 24 min* charging time is approximately
1 hour and 11 min (one battery)*
Lock the Mounting
Bracket.
B
Use a coin to adjust the
tightness of the tilt axis.
Power Outlet
100~240 V
(50Hz/60Hz)
B
A
*Provided charger
Low
High