Charge The Batteries - DJI MATRICE 200 Guia De Inicio Rapido

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
Using Matrice 200
1. Download the DJI Assistant 2 and DJI GO 4 App
Download and install DJI ASSISTANT
http://www.dji.com/matrice-200-series
Search 'DJI GO 4' in the App Store or Google Play, and download the app to your mobile device.
First-time activation requires your DJI account and internet connection.
Internet
DJI GO 4 app supports iOS 9 (or later) or Android 4.4 (or later).
If using a DJI CrystalSky
DJI Assistant 2 supports Windows 7 (or later) or OS X 10.11 (or later).

2. Charge the Batteries

Press the release button and open the corresponding charging port cover.
Insert the Intelligent Flight Battery into the charging port to begin charging.
1
A
2
Charging Time: 1.5 hours*
The Intelligent Flight Battery must be fully charged before using it for the first time. Be sure to press the release button on the top of the
Charging Hub when removing the fully charged battery.
When charging is complete, the LED lights on the Intelligent Flight Battery will turn off, and the LED on the Charging Hub will show green.
Power off the remote controller before charging. When charging is complete, the LED lights on the remote controller will turn off.
The Charging Hub will sound a signal when the battery has been fully charged. The sound can be turned on or off by toggling the switch
at the bottom of the hub.
Install the battery to the aircraft and power on. Once the battery temperature is lower than 15℃, it will auto heat to maintain a
temperature between 15-20℃.
Pairing batteries is recommended. This can be done inside the DJI GO 4 app. Ensure each battery pair is charged and discharged
simultaneously to prolong their service life and for a better flight experience.
3. Prepare the Remote Controller
Unfold the mobile device holder and the antennas.
Press the power button once to check the battery level.
Low
High
Strong
Weak
4
2 on your computer via the website link below:
TM
Monitor, it is recommended to use the built-in DJI Pilot app.
TM
Charging Time: 3 hours*
Unfold
B
Press the button to
release the clamp.
1
DJI GO 4 App
Power Outlet
100-240V
(50Hz/60Hz)
B
A
* Provided charger
Place your mobile
device and adjust
2
the clamp to
secure.
3
Connect your mobile
device with a USB
cable.

Publicidad

Tabla de contenido
loading

Tabla de contenido