JOUSTRA 46019176 Manual Del Usuario página 11

Setting up the weaving loom:
Fit the and the reel into the largest holes at each end of the frame sections.
warp beam
Then fit the two tubes (see illustration below).
When all the accessories have been fitted, clip the frame to the main base.
To finish, screw the caps to the
Warm beam
Reel
Attaching the threads:
1. Turn the
2. Cut the number threads of each necessary colour to form the
warp. They should be 60cm in length.
3. Form groups of threads: a maximum of 4 threads each, and tie them together at
one end.
4. Secure each knot between two large
teeth on the
in place using the slides.
5. Separate each thread and place them
one by one between the grooves on the
warp beam.
6. Turn the warp beam a full turn.
7. Then thread the threads as follows:
GB
COTTON THREADS AND BEADS
warp beam
so that the large teeth are facing up.
warp beam
warp beam, then hold them
LOOM:
and the reel.
4.
Loom comb
Loom comb
Base
5.