JOUSTRA 46019176 Manual Del Usuario página 12

Weaving:
Before starting, note that weaving is always done from the warp beam to the reel.
1. Cut a thread 60cm long and attach it to the first thread in the warp. Roll up your
thread around the shuttle.
2. Turn the
the vertical position. This has
the effect of splitting one thread in two.
Then pass the
threads and feed your threads from
the other side.
You've just weaved your first thread.
3. Turn the
the shuttle
direction.
4. Continue to weave in this manner.
The large comb separates the threads to give you a straight, tight weft.
When your weave is too close to the
at each end and slide it to the adjacent notches.
WARNING: Each thread must remain in its position between the teeth of the
5. Changing the colour of the thread: when you wish to change the colour, cut the
thread that you're weaving. Then, attach the end of it to a new thread, as close as possible to
the edge of the weave. Then start weaving again.
Finishing the weave:
Cut the shuttle thread 10cm from your weave and attach it to the the last warp thread by
making a knot.
Remove the slides, unwind the warp loom and the reel and remove your weave from the
loom.
Attach the warp threads 2 by 2 by making a double knot.
You can then make a braid at each end with all the excess threads.
loom comb a quarter of a turn to
shuttle between the "open"
loom comb half a turn, then feed
and your thread in the opposite
loom
2.
comb, remove it gently from the notches, holding it
3.
Shuttle
loom comb.