Advanced Settings - RIB MINI WIRELESS Manual Del Usuario

7
CLIMATIC SENSOR
7.1 Learning a climatic sensor
1. Press and release the learning key on MINI WIRELESS, the red LED lights up.
2. Press and release the key on the sensor. MINI WIRELESS signals the correct memorization with 2 flashes of the red LED.
Once memorized the sensor, you can test the transmission by pressing the key on the sensor. MINI WIRELESS shows the reception
of the broadcast with 1 rapid flashing of the yellow LED.
7.2 Checking the motor direction during an alarm of the sensor
This procedure is necessary to verify correct wiring of the motor, so that the awning will be closed in case of alarm.
1. Temporarily disable the operation of the light sensor DIP 5 OFF.
2. With a transmitter, or wired commands, move the awning at about halfway and stop it.
3. On the sensor you have to adjust the trimmer to minimum wind (TEST) and to rotate the blades of the sensor at a constant speed
for few seconds.
4. MINI WIRELESS will show the alarm with the blinking of the red LED and will reclose the awning.
If the awning opens => remove power to the control board. Swap the motor wires 14-15 and make the test above again.
If the awning closes => wait until it is completely closed. Press and hold the learning key until the red LED start blinking faster than
release the button.
Adjust the trimmer to obtain the desired wind speed on the sensor and re-enable the light sensors moving DIP 5 to ON.
7.3 Deleting a climatic sensor
1. Press and release the learning key on MINI WIRELESS. The red LED lights up.
2. Press and release the key on the sensor. MINI WIRELESS shows the deletion with 4 long flashes of the red LED.
8

ADVANCED SETTINGS

8.1 Setting the partial opening position (only with light sensor enabled - DIP 5 ON)
You can set a desired position for automatic opening due to the light sensor.
1. Close the awning
2. Upon reaching the closed position, press and hold the learning key on MINI WIRELESS until the red LED flashes rapidly. Release the
key
3. Press and hold the OPEN key of a transmitter or a wired push button (only with DIP 2 ON) until the yellow LED flashes quickly and
the awning begins to open. Release the button
4. To set the position it's sufficient to stop the awning (with a stop or a close command)
8.2 Temporary disabling of the rain and light sensors
This mode is used to temporarily disable the light and rain sensors (the rain sensor can be temporarily disabled only if DIP 3 ON)
1. Move the awning to the desired position
2. With the awning still in motion, press and hold for 5 seconds the stop "c" key or the key of opposite movement on the remote,
or the wired commands
3. MINI WIRELESS shows the disabling of the sensors with 1 flash each second of the yellow LED.
Rain sensor
DIP 3 ON => disabled for 2 hours.
DIP 3 OFF => never disabled.
Light sensor => disabled for a full cycle of light (night-day, day-night).
To exit the disabling sensors mode, it's sufficient to provide an open or close command and MINI WIRELESS will return to automatic
mode.
18