Removing The Shipping Bolts; Connecting The Water Lines - LG WM2240 Serie Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Removing the shipping bolts

Failure to remove the shipping bolts before using the
washing machine may cause severe vibration and noise,
which can lead to permanent damage to the machine.
Remove the shipping bolts and press the caps into the
shipping bolt holes.
1
Remove the shipping bolts at the back of the washing
machine with the wrench. (Supplied)
Shipping
bolt
2
Press the caps (supplied) into the shipping bolt holes.
Cap
NOTE
Save the bolts and other safety parts for future
y
use. The washing machine may be damaged or
malfunction if the shipping bolts are not installed
during transportation.

Connecting the water lines

1
Check the rubber seals on both sides of the hose.
- Insert a rubber seal into the threaded fittings on each
hose to prevent leaking.
Rubber seal
Water hose
(To water inlet on the
washing machine)
2
Connect the water hoses to the faucets.
- Connect the blue hose to a cold water faucet and the
red hose to a hot water faucet.
3
After connecting inlet hose to water tap, turn on the
water taps to flush out foreign substances (dirt, sand or
sawdust) in the water lines. Let water drain into a bucket,
and check the water temperature.
13
INSTALLATION
Rubber seal
Water hose
(To tap)

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido