Arm's Reach Co-Sleeper Manual Del Usuario página 12

Ocultar thumbs Ver también para Co-Sleeper:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Instructions
for securing the CO-SLEEPER
Connects to single, full, queen, king and
California king adult beds.
STEP 6
Unroll nylon straps from the plastic resistance
plate and lay straps across the adult bed to line
up with the center of the desired position of
your CO-SLEEPER
®
bassinet.
The straps must now be positioned between
upper and lower mattress or box spring.
This can be done by sliding the straps
between both mattresses using a back and
forth "sawing" motion and at the same time
pulling downward until the straps and
resistance plate are at the desired position.
One strap should come out on each side of
the CO-SLEEPER
®
bassinet. Pass through
"belt loop" found at front leg of CO-SLEEPER
bassinet.
Connect into the female buckle at the rear leg of
CO-SLEEPER
®
bassinet.
Pulling on excess strap, tighten CO-SLEEPER
bassinet against adult bed. Repeat on other side.
Take excess strap and pass it back through
"belt loop" and push it between adult mattresses.
4" minimum
®
WARNING:
!
®
The top edge of the bumper bar/shelf must be level with or below
the top of the adult bed mattress when used as a CO-SLEEPER
bassinet. The level of the CO-SLEEPER
a minimum of 4 inches below the top edge of the bumper bar/shelf.
NEVER raise the level of the CO-SLEEPER
with, or above the top of the bumper bar/shelf.
• Never use as a CO-SLEEPER
attached and locked as shown. Failure to use this anchoring
system could result in serious injury or death to the infant. Make
sure all straps are secured and tight. Check straps before each use.
• Failure to use this securing system will allow CO-SLEEPER
bassinet to move away from adult bed and could result in infant
falling out of CO-SLEEPER
in CO-SLEEPER
bassinet.
®
WARNING:
!
Do not allow excess strap (or any other loose object) to find its
way into the CO-SLEEPER
• Do not allow excess strap to lay loose on floor because someone
may trip on it.
• Make sure all Velcro
changer/CO-SLEEPER
• Use only fitted sheets for the CO-SLEEPER
by Arm's Reach Concepts, Inc.
12
®
bassinet to parental bed
You must use the nylon straps
and the resistance plate provided.
STRANGULATION / SUFFOCATION HAZARD:
bassinet mattress must be
®
®
bassinet mattress level
bassinet without the anchor plate
®
bassinet. NEVER leave infant unattended
®
STRANGULATION/ CHOKING HAZARD
®
bassinet.
®
straps are secured and tight when used in the
bassinet positions.Tighten straps periodically.
®
®
®
®
bassinet manufactured

Publicidad

Tabla de contenido
loading

Productos relacionados para Arm's Reach Co-Sleeper

Tabla de contenido