Arm's Reach Co-Sleeper Manual Del Usuario página 13

To convert to a changing table
To convert to a free-standing unit
B
A
Simply disconnect securing straps from CO-SLEEPER
unit where you desire.
WARNING:
!
STRANGULATION
assembly is not in use, store in a safe place not accessible to children.
• FALLING HAZARD Never leave infant unattended in changing table.
Changing table is not intended for sleeping.
WARNING:
!
Failure to follow these warnings and instruc-
tions could result in serious injury or death.
WARNING:
!
FALLING HAZARD: Remove infant from
CO-SLEEPER ® bedside sleeper before starting this conversion.
Starting from the completely assembled CO-SLEEPER
bassinet (with side lowered and liner installed)
STEP 1
A. Release Velcro ® on bottom front flap of liner from playard frame.
Place front flap over CO-SLEEPER
B. Open fabric flaps that cover the upper female receivers.
STEP 2
Unlock lower bar following instructions for Step 1 and Step 2 on page 9.
13
® bassinet and put the
When anchor plate and strap
® bassinet mattress to expose front bar.
®