Arm's Reach Co-Sleeper Manual Del Usuario página 6

Instructions
How to set up basic playard
WARNING:
!
store in a safe place not accessible to children.
WARNING:
!
and floor support rods. Lower the floor to the LOWEST level. Place the removable bar in the HIGHEST position.
• Always make sure all top and bottom rails are securely locked, in all configurations, before putting an
infant /child into the unit.
• NEVER LEAVE infant in playard with SIDES DOWN. Infant may roll into space between pad and loose mesh
side causing suffocation.
STRANGULATION HAZARD: When anchor plate and strap assembly is not in use,
Step 1
• Unzip bag. Remove playard and stand playard upright.
• Unhook Velcro
• Set mattress aside.
Step 2
• Separate the four corner posts. Leaving center up.
• Lock all top bars by grasping top bar in center and pulling up until
• Repeat on all 4 sides until all top bars are rigid.
Step 3
• Place foot on outside center pocket of bottom bar and push down to lock.
• Repeat on all 4 sides until playard is fully erect.
Step 4
A. To cover mattress with fitted sheet open the 4 Velcro
B. Feed Velcro
C. Feed Velcro
When converting to the playard configuration, remove the plastic hangers, the liner
tabs.
®
DO NOT PUSH CENTER DOWN OR LOCK LOWER BARS
BEFORE LOCKING ALL TOP BARS.
you hear a "click"
found on corner ends of mattress.
tabs thru buttonholes in sheet corners & place in bottom
®
of playard with Velcro tabs extended.
®
tabs thru corresponding buttonholes in floor of playard
®
corners and attach to snap on outside of leg.
6
tabs with snap
®