JUNO TC20LED-1554 Instrucciones De Instalación

TC LED Downlights with Lutron Hi-Lume
Commercial Recessed Housing
SAVE THESE INSTRUCTIONS
WARNING: For your safety, read and understand instructions completely before starting installation.
Before wiring to power supply, turn off electricity at the fuse or circuit breaker box.
NOTE: Juno recessed fixtures are designed to meet the latest NEC requirements and are listed in full compliance
with applicable UL standards. Before attempting installation of any recessed lighting fixture, check your local
electrical building code. This code sets the wiring standards and installation requirements for your locality and
should be understood before starting work. Use of non-Juno trims voids Juno warranty.
WARNING: Risk of fire. Do not install insulation within 3 inches of fixture sides or wiring compartment, nor above
fixture in such a manner as to entrap heat. (Fig. 1)*
* In Canada, when insulation is present, Type IC fixtures must be used.
TYPE TC FOR NON-INSULATED CEILINGS
3"
Juno Type TC fixtures are designed for installations where housing and
J-box will not come in contact with insulation. Insulation must be spaced
3" away from housing and J-box (Fig. 1). Improper fixture operation may
indicate improper insulation application.
1300 S. Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • Visit us at www.acuitybrands.com/juno-recessed
©2017 Acuity Brands Lighting, Inc
INSTALLATION INSTRUCTIONS
Figure 1
Rev 07/17
Driver (ECOS3 Option)
®
HOUSING INSTALLATION
BUTTERFLY
Figure 2
Step 1. Install housing into ceiling cavity by inserting 1/2" EMT, 3/4"
or 1-1/2" C-Channel, linear flat bars or Real Nail 3 bar hangers into butterfly
style mounting brackets (Fig. 2).
Step 2. Adjust butterfly mounting
brackets by loosening the carriage
adjustment bolt so bottom of plaster ring
is flush with finished ceiling line.
Mounting brackets have total vertical
adjustment of 3" (Fig. 3).
Step 3. Follow steps under
Electrical Connection.
Step 4. Cut appropriate sized hole.*
If necessary, adjust fixture for ceiling
thickness by loosening hex screws that
attach round housing to the plaster ring.
* Note: Cut 5-5/8" (for 5" housings) or 6-7/8" (for 6" housings) opening.
P5889
BRACKET
Figure 3
Hex Screws
Figure 4
CARRIAGE
BOLT
1 of 4