JUNO T272L30K90CRIFLWH Instrucciones De Instalación

WARNING: For your safety, read and understand instructions completely before starting installation.
Before wiring to power supply, turn off electricity at the fuse or circuit breaker box.
Note: Use with non-Juno fixtures voids Juno warranty.
SAVE THESE INSTRUCTIONS
Installation Instructions for Lens Replacement
Step 1. Remove the fixture from the trac and place it face up as shown in
(Figure 1).
Step 2. Grasp the lens retaining ring as shown in (Figure 1), away from the
locking dimples.
Step 3. Rotate the lens retaining ring about 1/8 turn counterclockwise and remove.
Step 4. Note the position and orientation of the part number tab on the original lens
as shown in (Figure 2).
Step 5. Carefully remove the original lens and replace with the accessory lens,
installing it with the part number tab in the same orientation as the original
lens. DO NOT TOUCH EITHER FLAT SURFACE OF THE LENS AS
SCRATCHES AND FINGERPRINTS MAY ALTER ITS PERFORMANCE.
Step 6. Replace the lens retaining ring, again grasping it away from the locking
dimples. Rotate the lens retaining ring about 1/8 turn clockwise until it clicks
into place.
Installation Instructions for Installing Hex Cell Louver
Step 1. Remove the fixture from the trac and place it face up as shown in (Figure 1).
Step 2. Grasp the lens retaining ring as shown in (Figure 1), away from the
locking dimples.
Step 3. Rotate the lens retaining ring about 1/8 turn counterclockwise and remove.
Step 4. Install the hex cell louver as shown in (Figure 3). Center louver as necessary.
Make sure the lens tabs are seated properly.
Step 5. Grasp the hex cell louver/lens holder away from the locking dimples.
Rotate the hex cell louver/lens holder about 1/8 turn clockwise
until it clicks into place.
WARRANTY
Limited warranty located at:
www.acuitybrands.com/customerresources/terms_and_conditions.aspx
Technical Services Phone (888) 387-2212
1300 S. Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • Visit us at www.acuitybrands.com/juno-trac
©2017 Acuity Brands Lighting, Inc.
INSTALLATION INSTRUCTIONS
Rev 3/17 P3732
Figure 1
Lens Retaining Ring
Grasp here
Figure 2
Lens
Part number tab
Figure 3
Hex Cell
Louver/Lens
Holder
Hex
Cell
Louver
Lens
Part
Number
Tab
To remove
Grasp here
Locking dimple
Alignment
Tab
1 of 1