JUNO TC2022LED4-27K-U Instrucciones De Instalación

SAVE THESE INSTRUCTIONS
WARNING: For your safety, read and understand instructions completely before starting installation.
Before wiring to power supply, turn off electricity at the fuse or circuit breaker box.
NOTE: Juno recessed fixtures are designed to meet the latest NEC requirements and are listed in full compliance
with applicable UL standards. Before attempting installation of any recessed lighting fixture, check your local
electrical building code. This code sets the wiring standards and installation requirements for your locality and
should be understood before starting work. Use of non-Juno trims voids Juno warranty.
WARNING: Risk of fire. Do not install insulation within 3 inches of fixture sides or wiring compartment, nor above
fixture in such a manner as to entrap heat. (Fig. 1)*
* In Canada, when insulation is present, Type IC fixtures must be used.
TYPE TC FOR NON-INSULATED CEILINGS
3"
Figure 1
Juno Type TC fixtures are designed for installations where housing and
J-box will not come in contact with insulation. Insulation must be spaced
3" away from housing and J-box (Fig. 1). Improper fixture operation may
indicate improper insulation application.
WARRANTY
Juno Lighting Group provides five year limited warranty on LED components from date of purchase. Juno Lighting Group's obligation
is expressly limited to repair or replacement, without charge, at Juno Lighting Group's factory after prior written return authorization has been
granted. This warranty shall not apply to products which have been altered or repaired outside of Juno Lighting Group's factory. This warranty
is in lieu of all other warranties, expressed or implied, and without limiting the generality of the foregoing phrase, excludes any implied warranty
of merchantability. Also, there are no warranties which extend beyond the description of the product on the company's literature setting forth
terms of sale.
Product Services Phone (888) 387-2212
1300 South Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • www.junolightinggroup.com
INSTALLATION INSTRUCTIONS
with Universal Driver (-U Option)
Commercial Recessed Housing
HOUSING INSTALLATION
Step 1. Install housing into ceiling cavity by inserting 1/2" EMT, 3/4"
or 1-1/2" C-Channel, linear flat bars or Real Nail 3 bar hangers into butterfly
style mounting brackets (Fig. 2).
Step 2. Adjust butterfly mounting
brackets by loosening the carriage
adjustment bolt so bottom of plaster ring
is flush with finished ceiling line.
Mounting brackets have total vertical
adjustment of 3" (Fig. 3).
Step 3. Follow steps under
Electrical Connection.
Step 4. Cut appropriate sized hole.*
If necessary, adjust fixture for ceiling
thickness by loosening hex screws that
attach round housing to the plaster ring.
* Note: Cut 5-5/8" (for 5" housings) or 6-7/8" (for 6" housings) opening.
TC LED Downlights
BUTTERFLY
BRACKET
Figure 2
© 2016 Acuity Brands Lighting, Inc.
CARRIAGE
BOLT
Figure 3
Hex Screws
Figure 4
Rev 4/15 P5890 pg 1 of 2