Publicidad
Idiomas disponibles
Idiomas disponibles
TC LED Downlights with Lutron Hi-Lume
Commercial Recessed Housing
ELECTRICAL CONNECTION
INSTRUCTIONS
Step 1. Provide electrical service according
to your local electrical code to the junction
box located on the plaster ring. Supply wire
insulation must be rated for at least 90˚C
Step 2. Strip supply wires 3/8" and insert into
appropriate connectors. Connect black fixture
wire to hot, white fixture wire to neutral and
green fixture wire to ground.
1300 S. Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • Visit us at www.acuitybrands.com/juno-recessed
©2017 Acuity Brands Lighting, Inc
INSTALLATION INSTRUCTIONS
EMERGENCY BATTERY BACK UP
WITH REMOTE TEST SWITCH
(BR OPTION)
When the fixture is ordered with the emergency
battery back up option (BR), the housing comes
from the factory with the battery pack already
wired to the fixture and a test switch accessory
(shipped in same carton as housing).
Step 1. Provide electrical service according
to your local electrical code to the junction
box located on the plaster ring. Supply wire
insulation must be rated for at least 90˚C.
Note: For proper charging and function
of emergency battery, an unswitched hot
conductor must be connected to the battery
independent of the driver power.
Power for fixture and battery charging must
be from the same branch circuit.
Step 2. Refer to the instruction manual
provided by the battery manufacturer (Shipped
with the fixture) to complete wiring and
installation of emergency fixture and test switch.
DRIVER REPLACEMENT
Driver replacements must be performed by a
qualified electrician. Replacement kits can be
ordered to match your specific fixture type. The
replacement kits include detailed instructions for
driver replacement. Remove inner housing from
fixture to access driver.
Rev 07/17
P5889
Driver (ECOS3 Option)
®
TRIM INSTALLATION
After ceiling is finished and painted, remove
paint shield from fixture. Discard or recycle.
To install trims using COIL SPRINGS remove
OPTIC REFLECTOR by rotating 1/4 turn
counter-clockwise (Fig. 5). Connect trim springs
to fixture L-brackets as shown (Fig. 6).
Take note of flange details at top of OPTIC
REFLECTOR, align and insert in fixture and
rotate 1/4 turn clockwise until it stops.
To install trims with TORSION SPRINGS:
For lensed trims, it is not necessary to remove
OPTIC REFLECTOR. For lensed trims
equipped with an internal reflector, remove
the reflector supplied with the trim and discard
or recycle.
For hyperbolic trims, follow instructions provided
with the trim.
L-Bracket
Optic
Reflector
Figure 5
Coil
Spring
Figure 6
2 of 4
Publicidad
