How To Use; Getting Started - Black+Decker JMBD3181 Manual De Instrucciones

How to Use

This product is for household use only.

GETTING STARTED

• Remove all packing material, and any stickers from the product.
• Remove and save literature.
• Your juice extractor is partially assembled in the box.
• Take the appliance apart and wash all removable parts as instructed
in CARE AND CLEANING section of this manual. This will remove any
traces of dust or residue left from manufacturing and shipping.
• Place on a dry level counter to prepare to assemble.
ASSEMBLING YOUR JUICE EXTRACTOR
Important: Always make sure your juice extractor is unplugged before
starting to assemble.
1. Place juice bowl over base with juice spout facing toward the safety
locking lever. Lower juice bowl onto the base so that spout slides
through the oval ring on the base.
2. With both hands, hold the filter by the rim and center it over drive
shaft inside the juice bowl. Carefully lower filter into the juice bowl,
rotating slightly until it drops into place; press down firmly on the rim
to secure.
Note: When assembled properly, the filter will spin freely in the juice
bowl. To check that it is assembled properly, simply try spinning the
filter by the rim.
3. Place the lid on the juice bowl so that the pulp opening is positioned
over the pulp spout. Position the back of the lid over the edges of the
pulp spout first; then lower the lid to fit firmly against the base.
4. Engage the safety locking lever on both sides with the safety locking
slots on the lid. You should hear a click as it locks in place.
Important: Your juice extractor will not operate if the two safety
locking levers are not properly locked.
5. Tilt the pulp container slightly and place it directly beneath the pulp
opening. Push the bottom of pulp container inward so top edge slides
up, behind the pulp spout. Continue to press firmly on the bottom of
the pulp container until it fits snugly against the base. When correctly
positioned, pulp container will be completely covered by the pulp
opening in the lid.
Tip: To make cleaning easier, you may wish to line the pulp container
with a small plastic bag to catch the pulp as you juice.
Important: Your juice extractor will not operate unless the pulp
container is correctly placed.
6. Position the pitcher beneath the juice spout. Be sure that the juice
spout empties into the larger opening in the pitcher lid.
17