Care And Cleaning - Black+Decker JMBD3181 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Care and Cleaning

This product contains no user serviceable parts. Refer service to
qualified service personnel.
Important: Always unplug your juice extractor from the outlet before
cleaning.
CLEANING
1. Disassemble your juice extractor following the instructions in
DISSASSEMBLING YOUR JUICE EXTRACTOR.
2. Using a sponge or damp cloth, clean the base, rubber feet and
underside of the juice extractor. If necessary, you may use a damp
toothbrush or cloth to clean juice from the inside the drive shaft (on
top of motor base).
Important: Do not immerse the base in water or spray with water. Clean
only by wiping with a damp sponge, cloth or paper towel.
3. All juicer parts—except the base—are dishwasher-safe (top-rack
only) or you may wash in warm, soapy water, using any mild liquid
dishwashing detergent. Do not use any products containing ammonia
or scouring powders, as these can dull, scratch or mar the surface.
Use the cleaning brush provided to remove pulp left on any of the
removable parts. Do not use metal brushes or pads.
4. To clean the food pusher properly, remove the center cap in the cover
of the food pusher. To remove, grasp cap and lift directly out of food
pusher, using the notch for leverage. Once parts are dry, replace the
cap.
5. To clean the filter, use cleaning brush provided to make sure tiny holes
in mesh filter are not clogged. This can be accomplished by holding
filter basket under a running faucet while brushing the mesh filter
screen from both the inside and outside of the filter mesh.
REMOVING TOUGH STAINS
1. Due to powerful staining properties of carotenoids found in many
vegetables, particularly carrots, we suggest soaking any stained parts
overnight in one of the following solutions:
• Biodegradable soap in enough warm water to cover juice extractor
parts
cup bleach added to a sink full of warm water
1
4
• 1 part warm water to 1 part cider vinegar
small box of baking soda in enough warm water to cover juicer
1
2
parts.
Important: Never use ammonia or abrasive cleansers!
2. After soaking overnight, lightly scrub with soft bristle brush and liquid
detergent.
STORAGE
Store your juice extractor in a clean, dry place. Never wrap cord tightly
around the appliance. Do not put any stress on cord where it enters
juicer, as this could cause cord to fray and break.
22

Publicidad

Tabla de contenido
loading

Tabla de contenido