Andis SLII Instrucciones De Uso Y Cuidado página 5

screws (Figure C). Remove blade set from trimmer. Install new blade set,
making sure the blade yoke cradles the armature pin on trimmer (Figure D).
There is no need to adjust blade tension before use, as tension has been
preset at the factory. Align screw holes of blade set to screw inserts on
trimmer housing. Replace the screws. Before tightening down blade
screws, check alignment of blade set to housing, making sure that they
are parallel. Tighten down screws.
POWER ADJUSTMENT
Your Andis trimmer has been adjusted to line voltage at the factory.
However, because of voltage variations it may be necessary to adjust the
power setting for your area. If the power adjustment is off, you will usually
notice a "clatter", when the trimmer is on or introduced into the hair. (It is
normal for your trimmer to "clatter" for an instant when initially turned on).
TO ADJUST YOUR TRIMMER:
1. Oil the blades (Figure B).
2. The power screw is located in the lower part of the housing opposite
the switch (Figure E).
3. Turn your trimmer ON.
4. Using a standard screw driver that fits the slot, turn the power screw
counter clockwise until the trimmer clatters continuously. Then turn the
screw clockwise carefully until the clatter ceases.
5. Your trimmer is now adjusted to its optimum power setting.
FACTORY REPAIR SERVICE
When the blades of your Andis trimmer become dull after repeated use,
it is advised to purchase a new set of blades available through your Andis
supplier or through an Andis authorized service station. If you wish your
trimmer to be serviced as well, it should be carefully packed and mailed either
Parcel Post Insured, or U.P.S. to any Andis authorized service station. To find
an Andis authorized service station near you log on to www.andis.com
or contact our customer service department at 1-800-558-9441.
CAUTION: Never handle your Andis trimmer while you are operating a
water faucet, and never hold your clipper under a water faucet or in water.
There is danger of electrical shock and damage to your clipper. Andis
Company will not be responsible in case of injury due to this
carelessness.
5