Heath Zenith 5800 Instrucciones De Instalación

Model 5800: 3000 Lumen
READ ALL INSTRUCTIONS CAREFULLY BEFORE BEGINNING INSTALLATION.
Screw
Lag Screw
Washer
Nut
© 2014 HeathCo LLC
Installation Instructions
Photocontrol
Cover Plate
LED Dusk-to-Dawn
WARNING: Turn power off at the fuse or circuit
breaker.
NOTE: All wiring must be run in accordance with the
National Electrical Code (Canadian Electrical Code in
Canada) through conduit or another acceptable means.
Contact a qualified electrician if there is any question as
to the suitability of the system.
1. Select a location on a flat wall with structurally sound wood
and from 10 to 25 feet (3 to 7.6 m) from the ground. The wood
should be at least one inch thick to safely secure the fixture.
2. Using the fixture as a guide, mark the 3 mounting holes.
3. Install the two bottom lag screws first. Screw in the lag screws
so that there is about 3/8" (9.5 mm) of space under the head.
4. Place the fixture on these two screws and install the top lag screw.
Tighten the top lag screw first, then tighten the remaining lag
screws.
5. Secure your outdoor cable or flexible conduit to the cover plate
with a fitting in accordance with the National Electrical Code
(Canadian Electrical Code in Canada).
6. Connect the fixture wires to the service wires (black to black,
white to white, and bare or green wire to ground wire).
7. Install the cover plate. Secure with the two screws, washers, and
nuts provided.
8. Align the arrow on the top of the photocontrol with the arrow
on the socket and install (it will only plug-in one way).
9. Rotate the photocontrol so the arrow points north.
• If pole mounted, turn the socket so that the arrow points North.
• If wall mounted, turn the socket so that the arrow points
directly away from the wall.
Note: There is a stop to prevent the socket from turning all the
way around. If you have trouble turning the socket, try turning it
the other direction. Verify the photocontrol is securely seated in
the socket by twisting the photocontrol clockwise until it stops.
To test operation during daylight, cover the photocontrol with a
small box. Turn on the power. Not all photocontrols are alike. Some
may have a time delay of a few minutes, others will turn on as soon
as power is applied. Uncover the photocontrol and your unit will
operate automatically—on at dusk, off at dawn.
Security Light
206897-02A