Kohler 5701-W1-96 Guía De Instalación Y Cuidado página 8

Bond in accordance with national and
local codes. Open bonding lugs are
located at the top of the junction box.
120/240 VAC Source
N
L1
240 V
Neutral Bus
(In Breaker Box)
5. Make Electrical Connections – Latin America
NOTE: The electrical rating of the product is printed on a label on the lumbar end of the bath. The bath
with heated surface is designed to operate between 110 V and 240 V at either 50 Hz or 60 Hz.
WARNING: Risk of electric shock. Disconnect the power before performing the following
procedures.
WARNING: Risk of electric shock. Connect the bath to a properly grounded Ground-Fault
Circuit-Interrupter (GFCI) or Residual Current Device (RCD) for protection against line-to-ground
shock hazard.
IMPORTANT! The white wire should be connected to the load neutral terminal on the GFCI or RCD
breaker. The green wire is the equipment ground and must be connected to the neutral bus in the main
circuit breaker box.
Follow local electrical codes. Bond in accordance with local codes.
Remove the 120 V plug from the electrical cord on the junction box mounted to the control board.
Connect service to the junction box with a 240 V plug (not included) or hardwire connection.
NOTICE: For -2MW Music Models: Refer to the installation instructions included with the amplifier for
wiring and installation details. Position the amplifier anywhere within the shroud (not recommended) or
in a remote location. If installed within the shroud, the amplifier will need to remain plugged into the
electrical outlet at all times.
1237788-2-E
Breaker Box
Typical Single-Pole
Circuit Breaker
with GFCI
* Line Neutral
(White
Curly Wire)
* Equipment Ground
Typical 240 V Wiring Connection
* Connections to be Made
at the Circuit Breaker
Control Power
240 V
Junction Box
Load Neutral
Black (L1)
Field Wiring
(From Junction Box
to GFCI Breaker)
8
Wire Connector
Green (Ground)
From Control
White (Neutral)
Wire Connectors
Electrician to provide
suitable strain relief.
Kohler Co.