NEC MultiSync LCD195NXM Manual Del Usuario página 6

Display Setup
3. Place hands on each side of the monitor to tilt the LCD panel 30-
degree angle and lift up to the highest position (Figure 4).
4. Connect all cables to the appropriate connectors (Figure 4).
5. Place the power cable and audio cable into the specifi c hooks indi-
cated in (Figure 6).
6. Place the D-Sub and the DVI-D cable and USB cable into the specifi c
hooks indicated in (Figure 7). USB cable is used with NX models
only.
7. Make sure all cables are resting fl at against the stand (Figure 7).
- continued
Figure 4
Highest
Stand
Position
d
DC-OUT
Figure 6
30˚ Tilt
DVI Cable
Input1(DVI)
D-SUB Cable
4
Input2( D-Sub)
USB
USB (upstream)
USB (downstream)
USB Cable
(NX models
only)