General Information - Ingersoll Rand ATEX SP11J Serie Manual De Usuario

• Air pressure above 6.2 bar (620 kPa/90 psig) at the inlet may result in a source of ignition
caused by premature failure of bearings or other components due to excessive speed, output
torque or force.
• Proper lubrication and maintenance are required to prevent premature component failures.
Follow the recommendations in the Lubrication and Maintenance sections of the manual
supplied with the impact wrench.
• Replace the rear rotor bearing and front rotor bearing each time the tool is disassembled for
maintenance.
• Do not perform maintenance or repairs in an area where explosive atmospheres are present.
• Do not clean or lubricate impact wrench with flammable or volatile liquids such as kerosene,
diesel or jet fuel. A potentially explosive atmosphere may be created.
To safely use this product and conform with the provisions of the Machinery Directive
98/37/EC, all instructions given in the accompanying literature, in addition to all
conditions, notices and warnings given herein, must be followed.
Safety Symbol Identification
Wear Respiratory
Protection
(Dwg. MHP2598)
Safety Information - Explanation of Safety Signal Words
DANGER
WARNING
CAUTION
NOTICE

General Information

Repair should be made only by authorized trained personnel. Consult your nearest
Ingersoll Rand Authorized Servicecenter.
Original instructions are in English. Other languages are a translation of the original instructions.
Manuals can be downloaded from www.ingersollrandproducts.com.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
04579744_ed8
NOTICE
Wear Eye Wear Hearing
Protection Protection
Indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided,
may result in minor or moderate injury or property damage.
Indicates information or a company policy that relates directly or
indirectly to the safety of personnel or protection of property.
CAUTION
EN
Read Manuals Before
Operating Product
EN-2